Plumbing Tips and Hints
Why does the water get hot in the shower when someone flushes the toilet?
Without getting too technical, plumbing code regulates how many water lines can be used to supply water to a certain number of fixtures. This allows plumbers to use the same pipe to feed cold water to both the shower and the toilet. So, though water pressure is adjusted to create the perfect balance of hot and cold at the beginning of a shower, when someone flushes the toilet in a home without a separate cold water feed, the sudden draw of cold water to refill the toilet tank causes a temporary decrease in the cold flow the shower is using, but doesn't decrease the flow of the hot. Hence, the scalding spray experienced by the unfortunates who live with inconsiderate roommates.
What makes pipes freeze and burst?
In short, water expands when it freezes. This is the same reason that sodas burst in the freezer. When you have a pipe full of water that is exposed to freezing temperatures, the water in the pipes expands as it freezes, causing a tremendous amount of pressure that will eventually cause the pipe to bust.
Why does the toilet keep running?
The is one of the most common plumbing questions asked. The usual reason is that the flap in the bottom of the tank isn't sealing shut. Take the top off the tank and flush the toilet while watching the rubber flap. Does it completely close? If not, even though water is entering the tank, some of it is flowing out through the unsealed flap and therefore, the water continues to run because the float ball trigger is never activated to stop the flow since water never reaches the fill line. That's why jiggling the handle works to stop the running. It's attached to the rubber flap with a chain, and jiggling it will reposition the flap so that it may seal more securely.
What is the most likely cause of a big increase on a water bill?
Though the first assumption would be a leaky pipe or faucet, the majority of increases in water bills are due to a leak in the toilet tank. This happens when parts become worn or are misaligned as in the example above with the running toilet.
Why does the faucet make a clunking sound when turned on?
Plumbing questions regarding noises almost always require something be tightened to remedy the situation. In this particular instance, the noise is probably caused by a loose washer in the faucet. Tighten everything up and the noise should disappear.
Here are some helpful tips in handling some of the most common plumbing problems. Call a professional plumber if you feel you're in over your head.
How do I clear a clogged drain?
If a drain is simply moving slowly, a clog may be starting to form or the vent system may be blocked. You can use a chemical drain cleaner to open a slow-moving drain, but be careful: Their caustic nature can damage certain kinds of pipes and upset the delicate chemical balance of a septic system. And if the drain becomes fully clogged, the caustic solution that fills the pipes and backs up into the bathtub or sink can burn your skin and make it dangerous to plunge or use a snake to clear the drain.
- Plunge the drain at the fixture.
- Try to clear out a hair blockage in a sink or tub drain with the help of a straightened coat hanger (bend a small hook at one end). To do this, first remove the pop-ups (hair and debris can collect around these assemblies).
- Connect a hydraulic bladder to a garden hose, and try to blast-out the clog.
- Try to clear the blockage with a snake, working from the fixture.
- Try to clear the blockage with a snake, working from a branch cleanout.